Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.

cancel

1

Subcategories

Active filters

  • Palmer PDI 06 L16 - Power Attenuator 16 Ohms

    €380.07

    Palmer Power Attenuator - Control the volume of your guitar amp

    The PDI06 is a power attenuator for live applications. The device is connected between the amplifier output and the speaker cabinet. It makes it possible to use the popular power stage distortion of tube amplifiers while reducing the associated high volume level. This permits practical volume reduction in five increments from 100% to 18% for stage and practice room situations. An additional level makes the speaker completely mute; the PDI06 then functions as a LOAD BOX and absorbs the entire output power of the amplifier.

    This mode of operation is useful, for example, when connecting an amplifier equipped with a speaker cabinet emulation directly to the mixing desk using an existing line-out and loud volume levels in the recording booth are undesirable. The unit has an input for the speaker signal from the amplifier and two outputs for connecting speaker cabinets.

    The total impedance of the speakers must equal the value shown on the PDI06. Example: the outputs of a PDI06, that is specified for 8 ohms, can be connected to one 8 ohm cabinet or two 16 ohm cabinets (the 16 ohm version has only one output). The output of the (tube) amplifier is also set to 8 ohms.

  • Palmer MONICON® W - Passive Monitor Controller White Limited Edition

    €94.71

    Palmer Monicon®, and the volume is right!

    With Palmer Monicon®, your monitor volume is always under control. The passive mini-mixer with the oversized control is inserted between the stereo output of the notebook, PC or interface and an active monitor system and thus permits convenient and precise volume control of the monitors from the workstation. The passive circuitry with only a few components has absolutely no affect on the sound. Mute and mono buttons make it possible to mute the outputs and merge the stereo output signal into a mono master signal.

    The inputs and outputs of the controller are equipped with XLR connectors and the 3.5mm stereo TRS sockets usually found on computers. Combo input sockets also permit connection with 6.3 mm TRS plugs. Thus the Palmer Monicon® is compatible with both professional and consumer equipment. Genuine wood sides make the practical studio tool in its massive powder-coated sheet steel housing an elegant looking little helper" that is a typical Palmer product.

    "
  • Palmer MONICON® - Passive Monitor Controller

    €92.25

    Palmer Monicon®, and the volume is right!

    With Palmer Monicon®, your monitor volume is always under control. The passive mini-mixer with the oversized control is inserted between the stereo output of the notebook, PC or interface and an active monitor system and thus permits convenient and precise volume control of the monitors from the workstation. The passive circuitry with only a few components has absolutely no affect on the sound. Mute and mono buttons make it possible to mute the outputs and merge the stereo output signal into a mono master signal.

    The inputs and outputs of the controller are equipped with XLR connectors and the 3.5mm stereo TRS sockets usually found on computers. Combo input sockets also permit connection with 6.3 mm TRS plugs. Thus the Palmer Monicon® is compatible with both professional and consumer equipment. Genuine wood sides make the practical studio tool in its massive powder-coated sheet steel housing an elegant looking little helper" that is a typical Palmer product.

    "
  • Palmer LI 06 - Line Level Converter 2 In 1 Out

    €123.00

    Today, lectures and presentations are mostly held with audio and visual media support. Connecting laptop computers to the mixing consoles of PA systems, however, can be a major problem due to incompatible connector formats. The Palmer Line Level Convertor PLI06 is a dedicated interface to feed the unbalanced stereo signal typically provided by a laptop to the balanced (mono) microphone inputs of professional mixing desks. It mixes the stereo output to mono while impedance matching and signal balancing are achieved by a high quality audio transformer especially designed for the unit. Moreover, it also prevents ground loops and the annoying hum they result in. The PLI06 is entirely passive and does not require mains power or batteries.

    Connecting the PLI06

    Equipment providing audio output on RCA phono sockets is connected to the PLI06's inputs using a shielded RCA stereo cable. For best results with laptops we recommend using their headphones output which is usually on a 3.5 mm miniature stereo socket. Use a shielded TRS mini jack to 2x RCA phono cable for connection to the PLI06. Place the unit close to the signal source and keep the input cable as short as possible since the unbalanced signal path is susceptible to interference. The PLI06's output is on a standard wiring male XLR connector. Use a high quality microphone cable for connection to the mixing console. Due to the balanced lo-Z signal provided by the Palmer Line Level Converter cable lengths are uncritical while interference- free signal integrity is maintained.

  • Palmer LI 01 - Line Isolation Box 1 Channel

    €102.09

    Mono isolation transformer (line isolator), equipped with 1/4 TRS jack sockets at both ends for balanced and unbalanced signals. Especially suitable for eliminating ground loops that cause hum. Conversion from unbalanced to balanced is possible. A two-channel version can be found under product number PLI05. Single channel unit in a small rugged diecast box. Especially useful in guitar rack systems where multiple signal processors and preamplifiers are combined. Also eliminates noise in car hifi when used to isolate power boosters.

    "
  • Palmer DI-REVERSE - Reversed DI Box

    €110.70

    Many try using a DI-Box “backwards” in order to convert a balanced signal to unbalanced. The resulting mismatch generally leads to disappointing results. The PDIR (DI-Reverse) offers a clean and reliable solution whilst additionally isolating the two connected devices via transformer.

  • Palmer GA 04 L 16 - Speaker Simulator with Loadbox 16 Ohms

    €618.69

    Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct pickup of the signal. The extensive filter section provides for a realistic simulation of classic guitar loudspeaker sounds.

  • Palmer PWC 6 - Power Distribution Cable for up to 6 Devices

    €7.38

    With the PWC6 you can power up to 6 units from one single power outlet. Considering that most common effects have a power consumption of approx. 20mA, a 300mA power supply such as the Palmer PW9V can thus often suffice to power 6 units.

  • Palmer GA 04 L0 4 - Speaker Simulator with Loadbox 4 Ohms

    €618.69

    Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct pickup of the signal. The extensive filter section provides for a realistic simulation of classic guitar loudspeaker sounds.

  • Palmer GA 04 - Speaker Simulator with Loadbox 8 Ohms

    €618.69

    Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct pickup of the signal. The extensive filter section provides for a realistic simulation of classic guitar loudspeaker sounds.

  • Palmer EP TREM - Tremolo Effect for Guitar

    €76.26

    Tremolo is an indispensable effect for the electric guitar that has never lost popularity since its inception almost 70 years ago. The Palmer Pocket Tremolo produces a vibrant volume modulation of the classic vintage effect as well as modern helicopter sounds. Speed and Intensity of the tremolo effect can be widely adjusted with the provided controllers, the Shape controller selects the type of modulation ranging from the smooth ups and downs of the sine wave, to the sharp on and off of the square wave.

    It is powered by an external 9 Volt power pack (hollow plug with a negative internal contact) such as the Palmer PW9V, or alternatively by a 9 Volt block battery.

  • Palmer ENCORE - Looper Pedal

    €131.61

    The Pocket Series ENCORE looper does it all with just one knob and footswitch: record, erase, undo, redo, stop and playback level setting. It lets you record up to10 minutes of loop phrases to create your own backing tracks on the fly. Add unlimited overdubs and layer loops for a bigger sound, all in uncompressed 24-bit quality for superb audio fidelity. The ENCORE’s true bypass switching ensures your guitar tone remains uncolored when the pedal is off.