Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.

cancel

Accessories for Guitar and Bass

Active filters

  • Palmer PDI 06 L16 - Power Attenuator 16 Ohms

    €380.07

    Palmer Power Attenuator - Control the volume of your guitar amp

    The PDI06 is a power attenuator for live applications. The device is connected between the amplifier output and the speaker cabinet. It makes it possible to use the popular power stage distortion of tube amplifiers while reducing the associated high volume level. This permits practical volume reduction in five increments from 100% to 18% for stage and practice room situations. An additional level makes the speaker completely mute; the PDI06 then functions as a LOAD BOX and absorbs the entire output power of the amplifier.

    This mode of operation is useful, for example, when connecting an amplifier equipped with a speaker cabinet emulation directly to the mixing desk using an existing line-out and loud volume levels in the recording booth are undesirable. The unit has an input for the speaker signal from the amplifier and two outputs for connecting speaker cabinets.

    The total impedance of the speakers must equal the value shown on the PDI06. Example: the outputs of a PDI06, that is specified for 8 ohms, can be connected to one 8 ohm cabinet or two 16 ohm cabinets (the 16 ohm version has only one output). The output of the (tube) amplifier is also set to 8 ohms.

  • Palmer BC400 AA V1 - Professional 19 Battery Charger with 16 Varta AA Batteries"

    €550.35

    Keep your microphones, in-ear monitors, effect pedals and other battery-powered devices operational at all times with the professional 19 Palmer BC 400 AA V1 battery charger. It is controlled by a micro-controller and charges up to 16 AA or AAA batteries at the same time, including a combination of each. Charging stations for two 9-volt blocks are available as accessories, and can be combined as needed with the AA/AAA charging stations.

    The Palmer 19" quick charger monitors the charging status of each individual battery, identifies defective batteries, and protects against overcharging and short-circuiting. The built-in multi-voltage power supply facilitates worldwide use. The Palmer BC 400 AA V1 includes 16 rechargeable Varta AA batteries.

    "
  • Palmer GA 04 L 16 - Speaker Simulator with Loadbox 16 Ohms

    €618.69

    Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct pickup of the signal. The extensive filter section provides for a realistic simulation of classic guitar loudspeaker sounds.

  • Palmer POCKET AMP BASS - Portable Bass Preamp

    €232.47

    Providing extensive sound shaping options for active and passive bass guitars, the Pocket Bass Amp is a multi-purpose effects pedal and preamp that‘s perfect for gigging, recording and practising. It features clean, overdrive and fuzz modes with adjustable drive and saturation, a 3-band EQ with semi-parametric mid control that is specifically tuned for bass guitar and vintage or modern cabinet simulation. A blend control allows you to mix the direct and effected signals.

    The Pocket Bass Amp provides an insert for external effects, 3.5 mm stereo line input and headphones output for quiet play-along practice and a footswitch-assignable thru jack for silent tuning. Enabling DI applications, the balanced XLR output is pre or post effect switchable. The Pocket Bass Amp requires a 9 volt battery or power adapter and comes in a rugged diecast enclosure with heavy duty long-life footswitch, convenient LED status indicators and ground lift.

  • Palmer POCKET AMP ACOUSTIC - Portable Preamp for Acoustic String Instruments

    €241.08

    Providing extensive sound shaping options for acoustic guitars and basses, the Acoustic Pocket Amp is a versatile preamp that‘s perfect for gigging, recording and practising. It accomodates both piezo and magnetic pickups, and the 3-band EQ with semi-parametric mid control is specifically tuned for acoustic instruments. The Pocket Preamp features an input limiter to prevent transient distortion while a 5-position rotary notch filter eliminates resonant frequency feedback. A mode switch selects between crisp contemporary or warm vintage sound characteristics, and a blend control allows you to mix the direct and processed signals.

    The Acoustic Pocket Amp provides an insert for external effects, 3.5 mm stereo line input, headphones output and a footswitch-assignable thru jack to connect a tuner. Enabling DI applications, the balanced XLR output is pre or post signal processing switchable. The Acoustic Pocket Amp requires a 9 volt battery or power adapter and comes in a rugged diecast enclosure with heavy duty long-life footswitch, convenient LED status indicators and ground lift.

  • Palmer MACHT 402 - 19 Stereo Power Amp for Guitar"

    €467.40

    The Palmer MACHT 402 is a 19 stereo power amplifier specially designed for guitar applications. It pumps out 200 watts per channel and 400 watts bridged to drive virtually all speaker cabinets. Featuring a highly efficient switch mode power supply and low noise fan the soft start class D design is protected against overvoltage, DC, short circuits and overheating.

    Conventionally named, the channels' Hi and Low controls have been carefully tailored for guitar signals to provide extensive EQ facility, a wide variety of sounds and authentic tube power stage characteristics. In addition, the MACHT 402 sports rumble filtering, LED indicators, a 3-way sensitivity selector, built-in limiter and ground lift switch. With XLR and 6.35 mm inputs as well as Speakon compatible and 6.35 mm output connectors the Palmer MACHT 402 is the ideal power station for guitar preamps, small amps, modelers and even effects pedals.

    Attention:

    The MACHT 402 is unsuitable for direct connection to a guitar. Please include a preamp, modeller or an effect pedal in between.

    "
  • Palmer MI PLB 2 X 8 - Dual Loadbox 2 x 8 Ohms

    €291.51

    The Palmer PLB2X8 is a dual-channel, strictly reactive load (load box). A load box is a substitute for a speaker. It ensures that tube amps are connected to the correct load on the output, thus eliminating the risk of amplifier damage.

    The PLB2X8 is a perfect addition to speaker simulators that do not have a built-in load (load box) (for example: PDI09, PGA05 and PDI05).

    The PLB2X8 is also useful in conjunction with guitar amps that have a line out or filter out connection. In this case, the PLB2X8 permits silent operation of the amplifier with simultaneous use of the line/filter output.

  • Palmer GA 04 L0 4 - Speaker Simulator with Loadbox 4 Ohms

    €618.69

    Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct pickup of the signal. The extensive filter section provides for a realistic simulation of classic guitar loudspeaker sounds.

  • Palmer GA 04 - Speaker Simulator with Loadbox 8 Ohms

    €618.69

    Special DI box with loadbox for guitars. The integrated load resistor permits tube amplifiers up to approximately 120 W to be connected to the PGA04, bypassing a loudspeaker. A jack socket (unbalanced) and balanced XLR connector are available for direct pickup of the signal. The extensive filter section provides for a realistic simulation of classic guitar loudspeaker sounds.

  • Palmer EP TREM - Tremolo Effect for Guitar

    €76.26

    Tremolo is an indispensable effect for the electric guitar that has never lost popularity since its inception almost 70 years ago. The Palmer Pocket Tremolo produces a vibrant volume modulation of the classic vintage effect as well as modern helicopter sounds. Speed and Intensity of the tremolo effect can be widely adjusted with the provided controllers, the Shape controller selects the type of modulation ranging from the smooth ups and downs of the sine wave, to the sharp on and off of the square wave.

    It is powered by an external 9 Volt power pack (hollow plug with a negative internal contact) such as the Palmer PW9V, or alternatively by a 9 Volt block battery.

  • Palmer ENCORE - Looper Pedal

    €131.61

    The Pocket Series ENCORE looper does it all with just one knob and footswitch: record, erase, undo, redo, stop and playback level setting. It lets you record up to10 minutes of loop phrases to create your own backing tracks on the fly. Add unlimited overdubs and layer loops for a bigger sound, all in uncompressed 24-bit quality for superb audio fidelity. The ENCORE’s true bypass switching ensures your guitar tone remains uncolored when the pedal is off.

  • Palmer MI POCKET DISTORTION - Distortion effect for guitar

    €51.66

    For those who like a harder edge and lots of gain on top the Palmer Pocket Distortion is a must. Designed for modern sounds with much muscle, this powerful stompbox delivers way more dirt than a stock overdrive pedal. The Pocket Distortion's Tone control provides a very wide sweep for effective sound adjustment without altering your guitar's inherent tone.

    The Pocket Distortion works on a 9V battery or optional power adapter, e.g. Palmer PW9V.